Filter
Top Products
2-6
VRC 6940 Product Reference Guide
Figure 2-7. Adding an In-line Fuse Holder
b. Route the External DC power cable from the terminal location to the connection
point for your vehicle’s power source.
See the Installation Note below.
In-line fuse holder with
5A slow-blow fuse
Twist-on nylon
Wrapped wires
Red power wire
i.
ii.
iii.
iv.
v.
wire connector
and fuse holder
Installation Note: Cable Routing Caution
The means of routing and securing the External DC power
cable from the terminal to the vehicle power source is
extremely important. Hazards associated with improper
wiring can be severe.
To avoid unintentional contact between the wire and any
sharp edges, provide the cable with proper bushings and
clamping where it passes through openings. If the wire is
subjected to sharp surfaces and excess engine vibration,
wiring harness insulation can wear away, causing a short
between the bare wire and chassis. This can start a fire.
! !