Filter
Top Products
Chapter 3: Operation 3-25
➤ To delete a waypoint using the cursor:
1. Move the cursor over the waypoint until the letters
WPT are displayed.
The waypoint soft keys are displayed.
2. Press the
ERASE WAYPOINT soft key. The waypoint is removed from
the screen and the Waypoint List is updated.
Moving a Waypoint
You can move any waypoint except the target waypoint (the waypoint
you are navigating towards). You can use the Waypoint soft keys and
cursor to move the selected waypoint, or you can edit the waypoint
position.
CAUTION:
Take care when editing waypoints as it is possible to move waypoints
that are used in routes stored in the Route List.
➤ To move a waypoint using the Waypoint Edit functions:
1. Select the waypoint using either the cursor or the Waypoint List as
described in Selecting a Waypoint on page 3-22; the waypoint soft
keys are displayed.
2. To edit the waypoint position, proceed as previously described in
Editing Waypoint Details on page 3-23.
➤ To move a waypoint using the cursor:
1. Move the cursor over the waypoint, until the letters
WPT are dis-
played.
The waypoint soft keys are displayed.
2. Press
MOVE WAYPOINT, the cursor changes to a four-headed arrow.
3. Move the cursor to the required waypoint position.
4. Press
ENTER to set the position and return to normal cursor control or
press
CLEAR to cancel the operation.
81167_3.BOOK Page 25 Wednesday, November 21, 2001 2:12 PM