Raymarine 320 GPS Receiver User Manual


 
3-38 Raychart 320 Chartplotter
Going To an Individual Target Point
Rather than following a route, you can go directly to a selected target
point. This can be an existing waypoint (not in the current route) or the
cursor position.
To navigate directly to an existing waypoint:
1. Select the waypoint from the Waypoint List as described in
Section 3.4.
or...
Using the trackpad, position the cursor over the required waypoint
until the letters
WPT and the waypoint soft keys are displayed as
shown in Figure 3-27
2. Press the
GOTO WAYPOINT soft key.
Navigation to the selected waypoint begins. The soft key
STOP GOTO
is displayed.
3. To return to the default soft key display, move the cursor away from
the waypoint or press
CLEAR.
To navigate directly to the cursor position:
1. Use the trackpad to position the cursor as required.
2. Press the
GOTO default soft key, followed by GOTO CURSOR.
If navigation is currently in progress you are warned
ALREADY FOL-
LOWING ROUTE. CANCEL ROUTE AND GOTO CURSOR?
i. To cancel the GOTO CURSOR operation, press NO.
ii. To continue with the
GOTO CURSOR operation (and stop the cur-
rent
GOTO ROUTE), press YES.
A temporary waypoint is placed as the target and navigation starts
towards it. The waypoint is shown as a square with a circle and dot at
its centre and is connected to the vessels starting position with a
dashed line.
The
STOP GOTO soft key is displayed.
Note: The temporary waypoint is not added to the Waypoint List. When
the
GOTO is complete or is stopped, the temporary waypoint remains on
the chartplotter screen until either another Goto or Follow is started or it
is removed.
3. To return to the default soft key display, move the cursor away from
the waypoint or press
CLEAR.
81167_3.BOOK Page 38 Wednesday, November 21, 2001 2:12 PM