Filter
Top Products
Chapter 2: Getting Started 2-9
• If Plotter Mode is On, the scale is decreased and the message
NO CHART DATA is displayed. The vessel, waypoints, routes
and tracks are displayed without cartography.
The chart information is restored when you return to a chart scale for
which the information is available.
➤ To zoom out to a smaller-scale (less detailed) display, press the top of the
RANGE key as many times as required, up to the maximum scale of
1200nm.
Customizing the Display Options
The SCREEN soft key enables the following screen display options to be
set on or off:
• Cursor Box (
CRSR BOX)
• Chart Grid (
CHRT GRID)
• Personalized (
CUSTOM)
The factory default for these options is
ON.
Switching the Cursor Data Box On/off
The cursor data box provides the cursor’s position in latitude/longitude
and/or bearing/range.To see a full image, switch the data box off.
➤ To control the cursor data box:
1. Press the
SCREEN soft key.
2. Press the
CRSR BOX soft key to toggle the setting between ON and OFF.
To return to the default soft key display, press
CLEAR.
➤ To move the cursor box:
1. Use the trackpad to position the cursor over the box until the letters
BOX are displayed.
2. Press
ENTER to take control of the box, use the trackpad to move it to
the required position and press
ENTER again.
Switching Chart Grid On/off
The Chartplotter display can be set to show grid lines of latitude and
longitude which can help determine position on the chart.
➤ To turn the chart grid on or off:
1. Press the
SCREEN default soft key.
2. Press the
CHRT GRID soft key to toggle the setting ON and OFF.
3. To return to the default soft key display, press
CLEAR.
81167_3.BOOK Page 9 Wednesday, November 21, 2001 2:12 PM