Filter
Top Products
Chapter 3: Operation 3-29
4. Press the MAKE ROUTE soft key; the make route soft keys are dis-
played as shown in Figure 3-34.
Figure 3-34: Make Route Soft Keys
5. Move the cursor to the position on the chartplotter where the first
waypoint is to be placed, then press the
PLACE WAYPOINT soft key; the
new waypoint appears on the screen at the cursor position.
A new waypoint is temporarily added to the Waypoint List with the
first available waypoint number. The waypoints in the current route
are re-numbered to identify the new positions. The number shown
adjacent to the waypoint identifies its position in the route.
Note: The cursor can be positioned on an existing waypoint - the text
WPT indicates that the existing waypoint is being re-used rather than
placing a new one. Press
PLACE WAYPOINT to include this waypoint in the
route. If you Clear the route before it is Saved, the waypoint is removed.
6. Move the cursor to the next waypoint position. A dotted line connects
the cursor to the last placed waypoint.
7. Press
PLACE WAYPOINT again. The waypoint is placed and the dotted
line changes to a solid line.
If you placed the waypoint incorrectly, you can delete the last-placed
waypoint by pressing the
UNDO WAYPOINT soft key.
8. Repeat steps (6) and (7) until you have placed all your waypoints. Up
to 50 waypoints can be included in a route.
9. To remove a waypoint move the cursor over it and press
UNDO WAY-
POINT
; the waypoint is removed and the cursor is placed over the pre-
vious waypoint.
10. When all waypoints have been entered, press the
ACCEPT ROUTE soft
key (or
ENTER) to complete the route.
The new route is displayed on the screen and becomes the current
route, but it is not yet active.
➤ To use a combination of the Cursor and Route Building Table methods,
alternate between them using the
USE CURSOR/USE WPT LIST soft key.
The first waypoint of a new route is outlined with a square, indicating that
it will be the target waypoint when the route is activated. If selected, the
waypoint data box is displayed for the target waypoint.
PLACE
WAYPOINT
UNDO
WAYPOINT
ACCEPT
ROUTE
USE WPT
LIST
D4928-1
81167_3.BOOK Page 29 Wednesday, November 21, 2001 2:12 PM