Raymarine 320 GPS Receiver User Manual


 
3-8 Raychart 320 Chartplotter
The arrows either side of the steering instruction and pointing towards it
are dependent on the XTE. The first arrow is shown when the difference
reaches 0.01nm and the second at 0.05nm.
Textual data provides Position, SOG, COG, Bearing and Range to
waypoint, Time and Date, Time To Go (TTG), Steering Indicator,
Sunrise, Sunset, Fix Status and XTE. Any unavailable data is replaced by
dashes, one per character. When there is no GPS fix but there is a value for
the last fix, this is shown instead.
The waypoint name is shown unless there is no target, in which case
NOT
FOLLOWING
is shown. If Goto cursor is in progress, GOTO CURSOR is
shown.
The
FIX status indicates D-FIX for a differential fix, SD-FIX for a satellite
differential fix,
FIX for a GPS or other Fix, or NO FIX where a fix has not
been acquired. If the simulator is ON, the word
SIMULATOR appears after
the fix status.
BRG, RNG and XTE data relate to the target waypoint.
Time refers to local time zone which is set in the System Set Up menu, see
Chapter 4.
The Time To Go (TTG) and Estimated Time of Arrival (ETA) data relate
to the target waypoint (not the whole route) and are based on the Speed
Over Ground (SOG) towards the target. If the Velocity Made Good
(VMG) is negative, or data is not available, these fields are replaced by
dashes, one per character.
Sunrise and Sunset times are for today and at the vessels position.
81167_3.BOOK Page 8 Wednesday, November 21, 2001 2:12 PM