Filter
Top Products
3-32 Raychart 320 Chartplotter
3. Use the soft keys to toggle between ETA or HOURS (elapsed) time and
to change the Speed Over Ground (SOG) value used in the time cal-
culations. The current selections are highlighted.
➤ To change the SOG used for ETA calculations:
1. Press the
PLANNED SOG soft key to switch to PLANNED SOG.
2. Press the up or down
PLANNED SOG arrow soft keys to increment/dec-
rement the planned SOG value.
The Time values in the Route Information list are updated.
3. Press the
ACTUAL SOG key to use the actual SOG value rather than a
planned one.
4. Press
CLEAR to remove the Route Information window, then CLEAR
again to return to the route soft keys.
5. To return to the default soft key display, press
CLEAR.
Route Leg and Waypoint Information
➤ To display information about a route leg, move the cursor over the leg
until the letters
RTE appear. The Route Leg data box is displayed, together
with the Follow Route soft keys as shown in Figure 3-38.
Figure 3-38: Route Leg Data Box and Soft Keys
Note: If a route is being followed, the FOLLOW ROUTE soft key changes to
STOP FOLLOW.
To remove the data box, move the cursor away from the route or press
CLEAR.
➤ To display information about a route waypoint, move the cursor over the
waypoint until the letters
WPT appear. The Waypoint Data Box is
displayed with the Follow Route soft keys as shown in Figure 3-39.
ROUTE NOT NAMED
LEG 02 - 03
270°T 13.4nm
ROUTE 01
FOLLOW
ROUTE
EDIT
ROUTE
CLEAR
ROUTE
REVERSE
ROUTE
D4912-1
81167_3.BOOK Page 32 Wednesday, November 21, 2001 2:12 PM