Filter
Top Products
59
In the STATUS screen, press the #3 and #4 soft keys simul-
taneously to perform a Mini-Sweep. The MX60 will track
the new MPP based on the xed percentage value. Per-
form a Mini-Sweep any time a change to the input sys-
tem or the Park Mpp xed percentage value is changed.
In U-Pick %Voc mode, press the #3 and #4 soft keys and
the New Voc is displayed; in Auto Sweep mode, press the
#3 and #4 soft keys until Sweeping is displayed.
A user might want an MPP that falls outside of the xed percentages available in Park Mpp. With the
MX60, a user can manually adjust these values by single percentage points while observing a change
in the instantaneous watts made available with these adjustments.
To manually track and change the MPP voltage in either the Auto Sweep or U-Pick %Voc
MPPT Modes:
Press and hold the #3 soft key to decrease the power
point voltage (PV voltage). Press and hold the #4 soft key
to increase the power point voltage (PV voltage).
Observe the changes in the Watts value to determine
whether increasing or decreasing the PV voltage will
improve the available power to the system.
Press either soft key to adjust
PV voltage
PV 087 V Bat 12.0 V
05.0 A 35.8A
Watts 0430 Aux Off
kWHrs 00.0 B-MPPT
PV 087 V Bat 12.0 V
05.0 A 35.8A
Watts 0430 Aux Off
kWHrs 00.0 B-MPPT