Filter
Top Products
52
Auto Restart
Pressing and holding the #4 soft key for several
seconds selects among the three MX60 Auto ReStart
modes: 0, 1, and 2 (default). Auto ReStart allows the MX60
to perform internal recalibrations and eliminate any pos-
sibility of software errors. To change the mode, release
the #4 soft key and press and hold again.
• Mode 0— Auto ReStart mode is disabled; the MX60
recharges continuously from an available source and
never Restarts. Mode 0 would be chosen to avoid
spinning a microhydro generator every 1.5 hours.
• Mode 1—once every 1.5 hours, when the MX60 is in
Bulk, it will brie y Restart and initiate a full panel sweep.
This will not reset any counters or charging stages or
statistics.
• Mode 2— Auto ReStart every 1.5 hours; in Bulk, Absorb,
and Float modes, it will brie y Restart and initiate a full
panel sweep. This will not reset any counters or
charging stages or statistics.
PkBatV Voc HiVoc
012.2 070.2 076.9
B-MPPT Sunrise
EXIT NEXT 00:06:12
0 Auto Restart
1 Auto Restart
2 Auto Restart
The MX60’s sunrise-related activity can be in uenced. During certain days of the year, the sun never
“sets” in parts of Alaska, for instance, and the PV output is constant. The MX60 responds to these
situations by generating its own sunrise reading at either 24 or 25 hours with 25 hours being the
default value. After this 24 or 25 hour period, the MX60 automatically initiates a BULK cycle and logs the
daily KiloWattHour / AmpHour statistics and Float Time to be logged and accumulated in the Logging
screen. Pressing down and holding the third soft key, then releasing and pressing and holding again
for a few seconds, will toggle the value between 24 and 25 hours. Mini-sweeps at the selected sweep
interval will initiate on time in either of these modes. Press the <NEXT> soft key to view the secondary
Log2 screen.
After 3 hours of sleeping, the MX60 displays Zzzz…. This means that the next wakeup will cause the
daily KiloWattHour / AmpHour statistics and Float Time to be logged and accumulated in the Logging
screen. This (the next wakeup) will also initiate a Bulk charge cycle.