Filter
Top Products
47
In the Absorb Time Limits screen, the user can set the
minimum and maximum times the MX60 stays in the
Absorb recharge cycle.
MAXimum is adjustable from 0 to 4 hours.
MINimum is adjustable from 0 minutes (the
default) up to the MAX Absorb Time Limit minus
10 minutes. (EX: MAX Absorb Time = 2 hours or
120 minutes; MIN Absorb Time adjusted up to 110
minutes)
To adjust the limits, press either the <MIN+> or
<MAX+> soft key. When nished, press the <NEXT>
soft key to view the next screen.
ADVANCED MENU
Absorb Time Limits
000m 2hr
EXIT NEXT MIN+ MAX+
Bulk cycle begins Absorb charge is reached At zero, MX60 goes into FLOAT
Timer starts Timer begins counting to zero
NOTE: In BULK, the MX60 will charge as long as necessary to complete the cycle, regardless of the
timer’s set points.
• A Bulk cycle starts each morning. The charge timer (ChgT) is preset to the minimum Absorb time limit
(zero minutes) while the Bulk/Absorb Charge Timer counts up in minutes.
•
The timer stops when it reaches the Maximum Absorb Time or the Absorb voltage set point is met.
• The ChgT counts down to zero after the Absorb voltage is reached.
• At zero, the MX60 goes into Float stage and may brie y display “Bat Full” (Battery Full) then “Float.”
• When the battery voltage drops below the oat voltage set point, the MX60 recharges to maintain
this set point, employing the F(Float)-MPPT function.
• If the system cannot maintain the Absorb voltage set point during the Absorb cycle, the timer will
stop counting down and begin counting up towards the MAX Absorb time as the MX60 transitions to
Bulk (BMPPT). This up and down counting will continue until the charge timer counts down to zero. The
Absorb cycle can be disabled by setting the maximum to 0hr.
BULK
PV ARRAY VOLTAGE
FLOAT
50
45
40
35
30
25
20
S
N
O
O
Z
E
S
N
O
O
Z
E
ABSORB
SLEEP
Z
ZZZ
SLEEP
Z
ZZZ