Filter
Top Products
Occupant safety
62
1
Anchorage ring
2
Hook
X
Open the trunk and release the rear seat
backrest (Y page 205).
X
Fold rear seat backrest slightly forward.
1
Anchorage ring
2
Hook
X
Guide the top tether strap between head
restraint and top of the seat backrest.
The head restraint must be installed and
positioned such that the top tether strap
can pass freely between the head restraint
and top of the seat backrest.
X
Make sure the top tether strap is not
twisted.
X
Fold up anchorage ring 1.
X
Securely fasten hook 2, which is part of
top tether strap, to anchorage ring 1.
X
For safety, make sure hook 2 is attached
to anchorage ring 1 beyond the safety
catch, as illustrated.
X
Swing the rear seat backrest to the rear
until it engages.
X
Check the rear seat backrest to be locked
in its upright position (Y page 206).
Once hook 2 is attached, the child restraint
itself can be secured.
X
Install the child restraint system and
tighten the top tether strap according to
the child restraint manufacturer’s
instructions.
Child seat anchors – LATCH-type
G
Observe Safety notes, see
page 58.
This vehicle is equipped with two LATCH-type
anchors (at each of the rear seats) for the
installation of a LATCH-type child seat with
matching mounting fittings.
G
Warning!
Children too big for a toddler restraint must
ride in seats using regular seat belts.
Position shoulder belt across chest and
shoulder, not face or neck.
A booster seat may be necessary to achieve
proper seat belt positioning for children
over 41 lb (18 kg) until they reach a height
where a lap/shoulder belt fits properly
without a booster.
Install child seat according to
manufacturer’s instructions.
The child seat must be firmly attached to
the right and left side anchors.
An incorrectly mounted child seat may
come loose during an accident which could
result in serious injury or death to the child.
Damaged or impact damaged child seats or
child seat mounting fittings must be
replaced.
Safety and security