Filter
Top Products
Control system
136
Example illustration for setting the hour
X
Press button æ or ç to set the hours
or minute(s).
X
Press the reset button to confirm.
Setting the date
This function is only available in vehicles with
audio system.
Vehicles with COMAND system:
For information on setting the date in the
COMAND system, refer to the separate
COMAND system operating instructions.
X
Move the selection marker with button
æ or ç to the Time/Date submenu.
X
Press button j or k repeatedly until
the message Set Date Month, Set Date
Day, or Set Date Year appears in the
multifunction display.
The selection marker is on the current
setting.
Example illustration for setting the month
X
Press button æ or ç to set the
month, day, or year.
Lighting submenu
Access the Lighting submenu via the
Settings menu. Use the Lighting submenu
to change the lamp and lighting settings on
your vehicle.
The following functions are available:
R
Setting daytime running lamp mode (USA
only) (Y page 136)
R
Setting locator lighting (Y page 137)
R
Setting night security illumination
(Y page 137)
R
Setting interior lighting delayed shut-off
(Y page 138)
Setting daytime running lamp mode (USA
only)
X
Move the selection marker with button
æ or ç to the Lighting submenu.
X
Press button j or k repeatedly until
the message Headlamp Mode appears in
the multifunction display.
The selection marker is on the current
setting.
X
Press button æ or ç to select
manual operation (Manual) or daytime
running lamp mode (Constant).
With daytime running lamp mode activated
and the exterior lamp switch in position
M or U, the low-beam headlamps are
switched on when the engine is running.
In low ambient light conditions the following
lamps will come on additionally:
R
Parking lamps
R
Tail lamps
Controls in detail