Filter
Top Products
Audio system
166
X
Terminating a combined call: Press
button t.
The connection to both callers is
terminated.
TDMA or CDMA network phones
G
Warning!
Please do not forget that your primary
responsibility is to drive the vehicle. A
driver’s attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking
a telephone call.
If you choose to use the mobile phone
7
while driving, please use the hands-free
device and only use the mobile phone when
road, weather and traffic conditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a
vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
Using your Mercedes-Benz specified mobile
phone, a number of functions and operating
steps can be performed and displayed in the
audio system display.
Further operating instructions not covered
here can be found in the operating
instructions for the multifunction steering
wheel and the mobile phone.
If your audio system is set up for telephone
operation, the t symbol will appear in the
display.
When you insert your Mercedes-Benz
specified mobile phone into the mobile phone
cradle, you will be prompted to enter your PIN
for 30 seconds (Y page 162). This display
disappears when you press any button.
When your mobile phone is inserted into the
mobile phone cradle, you will see the
reception strength in the upper right-hand
corner of the display.
Switching on the telephone
Switching on the telephone
X
Press button h.
If you have programmed an unlock code for
the telephone, you must now enter the
code.
X
Enter code using buttons 1 to R.
X
If necessary, correct number entered with
the CLR soft key. Press soft key briefly to
delete the last digit entered; press soft key
and hold to delete the complete number.
X
Press OK soft key after entering correct
code.
The telephone is unlocked. If you have
entered an incorrect code, you must enter
the correct code.
Switching off the telephone
X
Press button h for approximately three
seconds.
PROCESSING appears in the display until
the telephone is off. Afterward, PHONE
OFF appears in the display.
7
Observe all legal requirements.
Controls in detail