Filter
Top Products
Audio system
151
Calling up wavebands for radios with SAT
X
Press FM, AM or WB soft key repeatedly until
desired waveband has been selected.
The FM, AM and WB wavebands are called
up one after another.
The waveband currently selected appears
in the upper left-hand corner of the display.
Selecting a station
The following options are available for
selecting a station:
R
Direct frequency input (Y page 151).
R
Manual tuning (Y page 151).
R
Automatic seek tuning (Y page 151).
R
Scan search (Y page 151).
R
Station memory (Y page 152).
R
Automatic station memory (Autostore)
(Y page 152).
The station search proceeds in the following
frequency increments:
R
200 kHz in FM range
R
10 kHz in AM range
Direct frequency input
X
Select desired waveband.
X
Press button *.
X
Enter desired frequency with buttons
1 to R.
i
You can only enter frequencies within the
respective waveband.
If a button is not pressed within four
seconds, the radio will return to the last
station tuned.
Manual tuning
X
Select desired waveband.
X
Press button S or T for
approximately three seconds.
X
Press button repeatedly until desired
frequency has been reached.
Step-by-step station tuning takes place in
ascending or descending order. Each time
the button is pressed, the radio tunes
further by 0.2 MHz. During manual tuning,
the radio is muted.
Automatic seek tuning
X
Select desired waveband.
X
Press button S or T briefly.
The radio will tune to the next highest or
next lowest receivable frequency.
i
If no station is received after two
consecutive scans of the complete
frequency range, then the scan stops at the
frequency from which it began.
Scan search
R
Starting scan search
X
Select desired waveband.
X
Press SC soft key.
SC will appear in the display. The radio
briefly tunes in all receivable stations
on the waveband selected.
R
Ending scan search
Controls in detail
Z