Filter
Top Products
Control system
141
Distance to empty
X
Press button ÿ or è repeatedly until
the first function of the Trip computer
menu appears in the multifunction display.
X
Press button j or k repeatedly until
the message Range: appears in the
multifunction display.
The calculated remaining driving range
based on the current fuel tank level
appears in the multifunction display.
If only very little fuel is left in the tank, a
vehicle at the fuel pump ¿ appears
instead of the remaining driving range.
Telephone menu
G
Warning!
A driver’s attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking
a telephone call. If you choose to use the
telephone while driving, please use the
hands-free device and only use the
telephone when weather, road and traffic
conditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a
vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
Never operate radio transmitters equipped
with a built-in or attached antenna (i.e.
without being connected to an external
antenna) from inside the vehicle while the
engine is running. Doing so could lead to a
malfunction of the vehicle’s electronic
system, possibly resulting in an accident
and/or personal injury.
You can use the functions in the Telephone
menu to operate your telephone, provided it
is connected to a hands-free system and
switched on.
X
Switch on the telephone and the audio
system (Y page 143).
Vehicles with COMAND system:
Refer to separate COMAND system
operating instructions.
X
Press button ÿ or è repeatedly until
the message Tel appears in the
multifunction display.
Which messages will appear in the
multifunction display depends on whether
your telephone is switched on or off:
R
If the telephone is off, the message Tel
Off appears in the multifunction display.
R
If the telephone is on:
The telephone will then search for a
network. During this time the
multifunction display is empty.
As soon as the telephone has found a
network, the message READY appears in
the multifunction display.
Controls in detail
Z