Filter
Top Products
445
Controls in detail
Driving systems
5 Bent blue guide line
̈ Back up with the set wheel angle.
The guide lines in the COMAND display
disappear. After a short distance, the
bent blue guide line 5 appears.
̈ Back up until bent guide line 5 inter-
sects the edge of the parking space,
e.g. the curb.
̈ Stop the vehicle.
6 Yellow and red guide lines for cornering
7 Blue guide line for straight driving
̈ With the vehicle at a standstill, turn
steering wheel as far as it will go in the
opposite direction.
The guide lines for straight driving 7
and cornering 6 appear in the
COMAND display.
̈ Back up using the set wheel angle until
blue guide line 7 for straight driving is
parallel to the edge of the parking
space, e.g. the curb.
̈ Now straighten out steering wheel and
back up until you still have just enough
room behind the vehicle.
While doing so, observe
Parktronic* (
୴ page 431) or Park As-
sist* (
୴ page 435) warning indicators.
i
If you turn the steering wheel too far, the
message “Steering wheel turned too far. Please
adjust steering wheel” appears on the COMAND
display. Turn the steering wheel back until the
message disappears and the extended blue
guide line 3 intersects with vertical blue guide
line 1.
If you back up using the wrong wheel angle, the
following appears in the COMAND display:
“Steering wheel turned too far. Park Assist dis-
abled.”. Pull out of the parking space and start
the parking procedure over again.
i
If you turn the steering wheel while backing
up, the following appears in the COMAND dis-
play: “The steering wheel position has been
changed. Park Assist disabled.”. Pull out of the
parking space and start the parking procedure
over again.