Filter
Top Products
104
Control systems
COMAND satellite radio (USA only)
Tuning in channels using channel pre-
sets
̈ Select “Audio” Ǟ “Audio” Ǟ “Sat Ra-
dio” Ǟ “Presets”.
or
̈ Press n when the main area is select-
ed.
The preset menu appears. The dot R
in front of a preset position indicates
that this is the channel currently select-
ed and being listened to.
̈ Select station preset and briefly
press n.
COMAND tunes in the corresponding
channel as long as it is included in your
subscription and is still available.
If the channel is not included in your
subscription, you will see the message
described in the section “Satellite radio
service is not activated” (
୴ page 102).
If the channel is no longer available or
only the preview channel is activated,
you will see the message “Invalid Chan-
nel”.
̈ Closing message: Press n.
Tuning in channels using manual chan-
nel number entry
̈ Select “Audio” Ǟ “Audio” Ǟ “Sat Ra-
dio” Ǟ “Sat Radio” Ǟ “Channel Entry”.
The menu for manual channel number
entry appears.
̈ Exiting menu without making an en-
try: Press L back button in the cen-
ter console (
୴ page 82).
̈ Increase or decreasing number:
Slide qmr or rotate ymz.
̈ Selecting next number: Slide omp.
̈ Confirming channel entry: Press n.
Further operation depends on whether
the selected channel number is valid or
if the channel is included in your sub-
scription.
i
Which channels are found by the channel
search function depends on which channels you
have subscribed to and the program category
you have selected (
୴ page 103).
i
This function is not possible when only the
preview channel is activated. If you try to tune in
a channel in this instance, you will see the
screen described in the section “Satellite radio
service is not activated” (
୴ page 102).