Filter
Top Products
170
Control systems
COMAND navigation system (entering a destination)
List of towns/cities without input char-
acters
1 Symbol for more selection options
̈ Selecting a town or city: Slide qmr
or rotate ymz.
̈ Canceling selection: Select “Back”
and press n.
or
̈ Press back button L in the center
console (
୴ page 82).
̈ Confirming selection: Press n.
Towns/cities with symbol 1 mean
that there is more than one in the se-
lected state (USA) or province (CDN).
Confirming one of these towns/cities
will take you to a further sub-selection.
If there are no other selection options,
the address input menu appears again.
It shows one of the following items of infor-
mation:
ț Town/city and state (USA) or province
(CDN)
ț Street, town/city and state (USA) or
province (CDN)
Which of the following menu items are now
available depends on the situation, or may
depend on the data version of the digital
map. The menu items which are not avail-
able cannot be selected.
ț “Map”: using the map to enter a desti-
nation (
୴ page 184)
ț “Street”: entering the street
(
୴ page 171)
ț “House No.”: entering the house num-
ber (
୴ page 175)
ț “Center”: entering the center
(
୴ page 173)
ț “Intersection”: entering the intersec-
tion (
୴ page 178)
ț “POI”: entering a point of interest
(
୴ page 188)
ț “Save”: saving a destination in the des-
tination memory (
୴ page 206)
ț “Start”: starting the route calculation
(
୴ page 181)
̈ Continuing or completing destina-
tion entry: Select one of the menu
items mentioned above.
i
The street is visible if you have entered it be-
fore entering the town or city.
i
In this case, using the map for destination
entry is based on the town or city seen in the ad-
dress input menu.
i
In this case, entering a POI is based on the
town or city seen in the address input menu.