Filter
Top Products
166
Control systems
COMAND navigation system (entering a destination)
Entering the zip code
̈ In the address input menu, select “Zip
Code”. A list of zip codes appears with
input characters; the input
characters 4 are automatically acti-
vated.
List of zip codes with input characters
1 Top list entry based on the input data
up to that point
2 Numbers entered by the user
3 Numbers automatically added by the
system
4 Input characters
5 Currently selectable numbers
6 Currently selected numbers
7 Currently non-selectable numbers
8 List of zip codes
While the numbers are being selected as
described below, the top list entry 1 al-
ways shows the zip code which best corre-
sponds to the input data as it has been
entered up to that point.
At the same time, COMAND automatically
supplements numbers 2 entered by the
user with other likely numbers 3.
̈ Selecting numbers: Slide omp or
rotate ymz.
̈ Confirming number selection:
Press n.
̈ Deleting individual numbers:
Select ) in the bottom line and
press n.
̈ Deleting an entire entry: Select ) in
the bottom line and press n until the
entire entry is deleted.
i
It is not possible to enter a zip code if you
have already entered other address data aside
from the state (USA) or province (CDN).
You can only enter those zip codes which are
saved on the digital map.
The available zip codes depend on the state
(USA) or province (CDN) most recently entered.
i
In the list of input characters 4, you can
only select numbers which can be currently en-
tered. Which characters are included depends
on the sequence in which you have entered your
destination and the data version of the digital
map.