Filter
Top Products
228
Control systems
COMAND system settings
̈ Selecting hour or minute(s):
Slide omp.
̈ Setting value: Rotate ymz or
slide qmr.
̈ Saving setting: Press n.
Setting the time zone and switching be-
tween Daylight Saving Time and stan-
dard time
̈ Setting time zone: Select “Vehicle” Ǟ
“System Settings” Ǟ “Time” Ǟ “Time
Zone”.
The country list appears. The dot R in
front of a list entry indicates the cur-
rent setting.
̈ Select the country in which you are cur-
rently driving.
A time zone list may also be displayed,
depending on the country selected.
̈ Select desired time zone.
Subsequent operation depends on:
ț whether your navigation system has
GPS reception
ț which country you have previously set
You may either:
ț manually switch between “Daylight
Savings Time (Summer)” and “Standard
time (Winter)” in a list
or
ț switch automatic Daylight Saving Time
to standard time changeover (and vice
versa) on or off
̈ Switching manually: Select “Daylight
Savings Time (Summer)” or “Standard
time (Winter)”.
The dot R in front of a list entry indi-
cates the current setting.
i
The increment value for setting the minutes
depends on the situation. If GPS reception is
available, it is 30 minutes. If GPS reception is not
available, it is one minute.
i
The correct time zone and Daylight Saving
Time/standard time must be set for the follow-
ing navigation system functions to operate cor-
rectly:
ț Route guidance on routes with time-depen-
dent traffic guidance
ț Calculation of estimated arrival time
୴୴