Filter
Top Products
388
Controls in detail
Driving and parking
Turning off with KEYLESS-GO*
̈ Press the KEYLESS-GO start/stop
button (
୴ page 337) to turn off the en-
gine.
With the driver’s door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
(
୴ page 336).
If you have started the engine with the
KEYLESS-GO start/stop button and can-
not turn it off as described above:
̈ Remove the KEYLESS-GO start/stop
button from the starter switch.
̈ Insert the SmartKey with KEYLESS-GO
into the starter switch.
The engine turns off. The starter switch
is in position 0 (
୴ page 336).
Releasing seat belts
̈ Press the seat belt release button
(
୴ page 361).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
i
In an emergency you can turn off the engine
while driving by pressing and holding the
KEYLESS-GO start/ stop button for
approximately 3 seconds.
!
If you turn off the engine using the
KEYLESS-GO start/stop button and open the
driver’s or passenger door, the transmission will
shift to park position P automatically.
Keep in mind that turning off the engine using
the KEYLESS-GO start/stop button alone only
will automatically shift the transmission to
neutral position N.
i
If you drive through an automatic conveyor
type car wash, you can switch on the ignition
with the KEYLESS-GO button and engage gear N
or insert the SmartKey into the starter switch.
!
Make sure the seat belt retracts fully so that
the seat belt and/or latch plate cannot get
caught or pinched in the door or in the seat
mechanism. This can damage the seat belt and
impair the effectiveness of the seat belt, and/or
cause damage to the door and/or door trim pan-
el. Such damage is not covered by the
Mercedes-Benz Limited Warranty.
Damaged seat belts must be replaced. Contact
an authorized Mercedes-Benz Center.