Filter
Top Products
282
Control systems
Voice Control telephone
“Save name” (COMAND address book)
Use the command “Save name” to create a
new entry in your COMAND address book.
After using the command, the system will
prompt you to enter a phone number.
Digits from “Zero” to “Nine” can be en-
tered (
୴ page 280).
Speak the telephone number
ț as a continuous string
or, with longer phone numbers,
ț in form of digit blocks (three to five dig-
its).
After each digit block (separate the digit
blocks by using an approximately
0.5 second pause), the Voice Control Sys-
tem repeats the recognized digits and
waits until you continue speaking.
After the command “OK”, you will be
prompted up to two times to input the
name. When repeating the name, make
sure that you pronounce it in the same
manner as during the first input. Otherwise
the name cannot be saved and the Voice
Control System cancels the save proce-
dure.
Sample dialog:
s Save name
t Please say the number first
s One two three
t One two three
s Four five six seven
t Four five six seven
s OK
t Please say the name
s John Smith
t Please repeat the name
s John Smith
t Do you want to save the number in
a category?
s No
t Name and number saved
i
The Voice Control System may recognize
names even if not saved in your voice. For opti-
mum call-up performance, however, you should
speak and save the names you intend to use
yourself.
i
You can also add a name to an entry by call-
ing up the corresponding menu on COMAND and
saying the name twice (
୴ page 214).