Filter
Top Products
230
Control systems
COMAND system settings
Starting new individualization
̈ Select “Vehicle” Ǟ “System Settings”
Ǟ “Voice Control” Ǟ “Start new indi-
vidualization”.
A prompt appears asking whether you
would like further information.
̈ Select “Yes” or “No”.
If you select “No”, the first part of indi-
vidualization begins.
If you select “Yes”, an information dis-
play will be shown with audio instruc-
tion.
̈ Closing display: Select “OK”.
The first part of individualization be-
gins.
At the end of the first part, you will see
a prompt asking whether you want to
begin the second part.
̈ Select “Yes” or “No”.
If you select “No”, individualization will
be canceled. The data from the first
part is saved automatically.
If you select “Yes”, the second part be-
gins.
Individualization is completed at the end of
the second part. You will see a message to
this effect. The data from the second part
is saved automatically.
Canceling during the first or second part
of individualization
̈ Select “Cancel”.
A prompt appears asking whether you
really do want to cancel.
̈ Select “Yes” or “No”.
If you select “Yes”, individualization will
be canceled. The data from the part at
which you exited is not saved.
If you select “No”, the part at which you
stopped begins again.
Deleting existing individualization data
̈ Select “Vehicle” Ǟ “System Settings”
Ǟ “Voice Control” Ǟ “Delete individu-
alization”.
A prompt appears asking whether you
really do want to delete.
̈ Select “Yes” or “No”.
The individualization data will either be
deleted or not, depending on your se-
lection.
i
It is only possible to start individualization
with the vehicle stationary. After starting the
session, the system will guide you through the in-
dividualization by means of acoustic instruc-
tions.