3-60 DISASSEMBLY, REASSEMBLY, INSPECTION, AND MAINTENANCE
Balancer
Balancer Shaft Journal Diameter Service Limit (minimum)
PTO Side Flywheel Side
FE170: 14.943 mm (0.5883 in) 14.933 mm (0.5879 in)
If the measured value is smaller than the service limit, replace the
balancer shaft.
* For details on the bore of the balancer shaft bearing hole, refer to
the section on Crankcase/Plain Bearing.
A: Crankshaft
B: Balancer Gear
C: Matching Mark
Reassembly
•
Install the balancer shaft in the crankcase by aligning the matching
mark on the balancer gear with the matching mark on the balancer
drive gear of the crankshaft.