Filter
Top Products
3-18 DISASSEMBLY, REASSEMBLY, INSPECTION, AND MAINTENANCE
Ignition System
Ignition Coil Reassembly (Air Gap Adjustment)
•
Rotate the flywheel so that the magnet on the flywheel is on the
opposite side of the area in which the ignition coil is to be installed.
•
Use two bolts to hand-tighten the ignition coil to the area in which the
coil is to be installed, and slide a 0.3 mm gap gauge between the foot
of the coil and the periphery of the flywheel.
•
Keep the ignition coil pressed towards the flywheel and evenly tighten
the coil retaining bolts to the specified torque.
Ignition Coil Air Gap
Standard: 0.3 mm (0.012 in)
Adjustable Range: 0.25 ~ 0.4 mm (0.010 ~ 0.016 in)
Ignition Coil Retaining Bolt Specified Tightening Torque
FE120 (M6 bolt): 6.0 N
m (0.6 kg m, 53 in lb)
FE170, 250, 290, 350, 400: 3.5 N
m (0.35 kg m, 31 in lb)
A: Magnet
B: Coil Foot
C: Coil Retaining Botls
D: Gap Gauge
Key Switch (engine switch) Inspection
•
Set the measurement range of the hand tester to Rx1 and check
whether the lead from the key switch exhibits the continuity indicated
in the table on the right.
If the leads exhibit the continuity indicated in the table on the right,
the key switch is good.