Filter
Top Products
4-14 On the road
Trip computer switchpack
mls/km
Pressing the ‘mls/km’ switch alternately
displays data in metric or imperial units.
A/B
Selects either A or B trip memory. Select
the required data using the column stalk
TRIP button and then pressing A/B will
show the A or B information for that data.
RESET
RESET resets the selected trip to zero.
Warning and Information messages have
priority over trip data and, if active, will
be displayed when the ignition is at
position ‘II’.
Note: If warning messages are hidden,
the warning/fault still exists and requires
investigation.
It also can be used to cycle through:
TRIP – ODOMETER – MESSAGES.
Setting the trip computer
At the start of the journey, or series of
journeys, to be recorded, reset the
computer memory to zero as follows:
1. Press the TRIP button on the end of
the left column stalk switch to select a
trip function. The computer will
display either TRIP A: or TRIP B: data.
2. Press the A/B switch to select the
trip (A or B) to be reset.
3. Press the RESET switch and hold for
3seconds.
The display will read:
RESETTING
TRIP A (or B)
then it will reset and display:
A: 0 (or B: 0) or the new value.
Note: All trip functions, for A or B
depending on which was selected, will be
reset.