Filter
Top Products
Roadside emergency 6-1
6 Roadside emergency
Inertia switch
In the event of an accident, an inertia switch will trip, isolating
fuel pump operation. Once the switch has tripped it must be
reset before attempting to restart the engine.
The inertia switch is located behind the trim on the right-hand
side of the vehicle, forward of the front door post, below the
fascia. Pull open the small panel in the trim to reset the switch.
Resetting the switch
!
WARNING:
To avoid the possibility of fire or personal injury, do not
reset the inertia switch if you see or smell fuel.
If no fuel leak is apparent, reset the inertia switch as follows:
1. Turn the ignition switch to position ‘0’.
2. Pull open the small panel in the trim.
3. Press down the flexible cover on the top of the inertia switch.
4. Turn the ignition switch to position ‘II’, pause for a few
seconds, then return the key to position ‘0’.
5. Make a further check for fuel leaks.
6. Close the trim panel.