Filter
Top Products
Roadside emergency 6-5
Temporary-use spare wheel
Observe the following warnings before
using the wheel.
!
WARNING:
1. Please note temporary-use spare
wheel warning label. Adhere to
instructions on the label. Failure
to comply can be dangerous.
2. When a temporary-use spare
wheel is fitted, drive with caution
and replace with the specified
wheel and tyre as soon as
possible.
3. Do not fit more than one
temporary-use spare wheel and
tyre assembly at one time.
4. The temporary-use spare wheel
must be inflated to the correct
pressure. See page 8-5.
5. Temporary-use spare wheel,
maximum speed is 80 km/h.
Note: Maintenance information for the
temporary-use spare wheel is the same as
given for normal tyres.
Locking wheel nuts
Some vehicles are fitted with one locking
wheel nut on each wheel. These can only
be removed using the extractor tube and
key socket located in the luggage
compartment.
The locking wheel nut has a cover which
makes it visually similar to standard
wheel nuts. The top of the cover has an
indentation (A) to aid identification.
Push the extractor tube firmly over the
locking wheel nut cover, as shown at (B),
until it is fully located.
Withdraw the extractor tube to remove
the cover.
Fit the key socket over the locking wheel
nut as shown at (C).
Fit the wheel nut wrench over the key
socket and loosen the locking wheel nut.
Locking wheel nuts have a letter stamped
on their upper surface. The key socket is
stamped with a corresponding number.
Only key sockets with the correct
matching number will fit the locking
wheel nut.
Should a new key socket be required,
note the letter on the locking wheel nut
and contact your Jaguar Dealer. Proof of
vehicle ownership will be required.