Filter
Top Products
Climate control 5-13
Ignition on
The climate control system operates in
position II (run) of the ignition switch.
When the ignition is switched to run or
the engine is started, the Jaguar logo will
be displayed briefly followed by the last
touch screen selected (e.g. radio).
The climate control system will be set to
the climate operating mode selected
previously.
Climate control touch screen
displays
There are two climate control touch
screens displays, one for the system on
state and the other for system off/ram air
mode. Smaller overlay displays appear
briefly when selecting air recirculation or
adjusting the fan speed.
Most climate functions can be selected
using the peripheral push buttons without
displaying the climate touch controls.
To select the touch screen
display, press the
CLIMATE button.
To exit the climate control screen, select
another system function, e.g. AUDIO.
AUTO mode
Automatic operation provides a
controlled environment over a
temperature range of 17°C (61°F) to
31°C (89°F) and should be regarded as the
normal operating mode.
To select automatic
climate control press the
AUTO button.
Select the required temperature.
The AUTO mode touch screen is shown
above. If the touch screen is not
displayed, press the CLIMATE button.
Front and rear screen heating and timed
air recirculation may be selected while
remaining in AUTO mode. Selecting any
other climate control push button or
touch screen button will cancel
AUTO operation.
Automatic operation cannot be
deselected using the AUTO button. To
exit AUTO mode, select another climate
mode or touch the SYSTEM ON/OFF
screen button to switch the system off.
Temperature selection
Set the required interior
temperature with the red
and blue arrowed
buttons. Press the red button to increase
temperature and the blue button to
decrease temperature.
The selected temperature will appear on
the LCD screen.
Pressing the buttons to select the
maximum or minimum temperature
settings causes the LCD display to change
to HI or LO respectively and cancel
AUTO mode.
To quickly jump from HI or LO to a
convenient midrange temperature of
23°C (73°F), press and hold AUTO for a
few seconds.