Filter
Top Products
Maintenance 7-11
Check coolant level
The coolant level must only be checked
when the engine is COLD.
Refer to page 7-5 for coolant header tank
location.
!
WARNING:
Do not remove the coolant header
tank filler/pressure cap while the
engine is hot. If the cap must be
removed, protect the hands against
escaping steam and slowly turn the
cap anti-clockwise until the steam
pressure starts to escape. Leave the
cap in this position until the pressure
is released, and then remove the cap
completely.
The coolant level should be between the
two marks located on the side of the
header tank. If persistent coolant loss is
noticed, report this to a Jaguar Dealer to
have the cause investigated at the earliest
opportunity.
Replenishing
!
WARNING:
Do not allow anti-freeze to make
contact with skin or eyes. If this
should happen, rinse the affected
area immediately with plenty of
water.
Caution: Anti-freeze will damage
paintwork. Avoid spillage.
Replenish with the correct strength
anti-freeze and water, (see next page),
until the coolant is within the ‘max’ and
‘min’ marks on the header tank.
Refit the filler cap and hand tighten
securely until the ratchet operates.