Filter
Top Products
65
Wipers and Washers
R
Wipers and Washers
WINDSHIELD WIPERS
The windshield wipers and screen wash
functions are controlled by the right-hand
column stalk and only operate with the
ignition system ON.
Note:
•
Do not operate the wipers on a dry
screen.
•
In freezing or very hot conditions,
ensure that the blades are not stuck to
the glass.
•
In winter, remove any snow or ice from
around the arms and blades, including
the wiped area of the of the windshield
and the heater air intakes. If the wiper
blades have stuck to the glass, an
electronic cut-out may temporarily
prevent the wiper motor from
operating. If this occurs, switch OFF
the wiper and the ignition system.
Clear the obstruction and try again.
The stalk functions are as follows when
placed in the shown positions:
1. Windshield wipers off and parked.
2. Intermittent wipe.
3. Normal speed wipe.
4. Fast speed wipe.
5. Intermittent wipe rotary collar.
Intermittent wipe
When intermittent wipe 2 is selected, the
delay between wipes can be varied by
turning the rotary collar 5 to the required
delay position. Rain sensor wiper
operation is selected by turning the collar
to AUTO.
Note: If configured, the delay period for
each collar position (excluding AUTO),
automatically increases and decreases
with vehicle speed.
Flick wipe
Pull the stalk towards the steering wheel
for a single wipe. Holding the column
switch in this position will operate the
wipers continuously at normal speed until
released.
JAG0050G
1
2
3
4
5
JAG0124G
JAG0123G