Filter
Top Products
Cruise Control
170
L
Note: The set speed can be increase or
decrease the speed in steps of 1 mph
(2 km/h) by rolling the speed adjustment
control upwards (+) or downwards (-)
briefly until the desired speed is obtained.
Resuming the speed
If the vehicle is accelerated above the set
speed, then the set speed will be resumed
when the accelerator pedal is released.
If CANCEL is pressed, or the brake pedal
is pressed, the cruise control will
disengage but the set speed memory will
be retained. Press RESUME and the
vehicle will return to the set speed.
Note: Cruise control will not resume at
speeds below 30 km/h (18 mph).
RESUME will not operate if the ignition
has been turned OFF.
Caution:
• RESUME should only be used if the
driver is aware of the set speed and
intends to return to it.
• It is not recommended to resume
set speed when a low gear is
selected as excessive engine
speeds will occur.
Cruise control will switch OFF and clear
the memory when:
• The ignition system is switched OFF.
• A fault occurs. The cruise control
system will switch OFF and cannot be
used until the fault is cleared.
Automatic switch off
Cruise control will switch off but the set
speed will remain in the memory when:
• The CANCEL button is pressed.
• The brake pedal is pressed.
• Speed falls below 30 km/h (18 mph).
• Neutral, Park or Reverse gear
positions are selected.
• Dynamic stability control is operating.
• The difference between the actual and
set speed is too great.
• When the vehicle reaches a maximum
speed of 192 km/h (120 mph).
• The accelerator pedal is used to
accelerate beyond the set speed for
too long a period.