Filter
Top Products
6-11
· The speed (SPD) field is highlighted. Enter the intended speed,
and press ENT.
· The fuel flow (Flow) field is highlighted. Enter the estimated fuel
flow followed by ENT.
· The GPS 75 will now display the calculated figures.
To perform a Trip and Fuel Plan for a route...
· Highlight the first cyclic field (top
left), and select “RTE” with CLR.
· Highlight the next cyclic field and
select the desired route number
by pressing CLR.
· Highlight the “Leg>” field and select the desired leg, or select “All”
for the entire route, using CLR.
· Highlight the “SPD:” field and enter the intended speed, followed
by ENT.
· Highlight the “Flow:” field and enter the estimated fuel flow
followed by ENT.
· The GPS 75 will now display the calculated figures.
6.12 MESSAGES
You may recall from Section 2.6 that
some messages will remain on the
Message Page after being viewed.
When this occurs, the “MSG”
annunciator remains on (but does
not flash) in the lower left corner. To
view these messages, select
“Messages” from the Auxiliary Page.
See Appendix A for a description of
available messages.