Filter
Top Products
Home
>
4. Vizomo
>
4.2 General Overview
>
4.2.4 Power Up
4.2.4 Power Up
Follow the steps below to power up the processor:
1.
Attach the included IEC
-
C13 power cord to the unit via the IEC
-C14 socket.
2. Plug the other end of the cord into a grounded 100-240V power source.
3. Attach any other cables that are relevant to your setup.
4. Ensure the power switch of the PSU is in the ON position.
5. Press the Vizomo's power switch on the front of the unit behind the locking door.
6.
Once Vizomo has finished booting, it can be administered by Vizomo Controller and RasterMAPPER.
74 . 4. Vizomo
PXL System