Filter
Top Products
Home
>
3. Helix P1
>
3.4 Helix P1 Assembly & Mounting
3.4 Helix P1 Assembly & Mounting
PXL Node Box Mounting
The PXL Node Box has six double
-ended keyhole slots for mounting.
The center hole is 8.5mm in diameter
The slots are 4.5mm in diameter
When used indoors the PXL Node Box may be mounted in any orientation.
When used outdoors, or in any wet location, the PXL Node Box must be mounted with the connectors facing down, as follows:
The membrane vent located on the connector panel is rated for IP65 (all other components of the enclosure are rated for IP66 or better).
The vent will withstand standing water (up to IP67) for 30 minutes, so for continuous use in an outdoor or wet environment the box must me mounted so
the connectors and membrane vent are facing down. This will prohibit and liquid water from pooling on or around the vent.
P1 Pixel String Mounting
The pixel strings are rated IP66 and can be mounted in any orientation, both indoors and outdoors.
Follow the following safety guidelines when mounting the strings:
●
Do not flex the cable beyond its minimum bend radius of 10mm
● Do not flex the cable near the entry to the plastic pixel housing
● Do not deform the cable with mounting hardware
● If using a cable staple, use an insulated plastic version, like this:
NOT this:
3. Helix P1 . 43
PXL System