Filter
Top Products
Home
>
2. C
-
series Tile
>
2.3 Assembly & Mounting
>
2.3.4 L-Bracket
2.3.4 L
-
Bracket
In addition to the Center Mount there are two M10 threaded holes in the back of each C-series tile that may be used for permanent mounting or attaching
other accessories.
The two threaded holes are located underneath the Center Mount.
Removing the Center Mount Socket
Use of the L-bracket require the removal of the center mount socket from the rear of the tile as described in the following steps.
1 Place the tile on a flat surface, protecting the front of the tile from damage to the LEDs.
2 Remove the 5 screws from the retaining ring.
3 Remove the retaining ring and locking ring.
Installing the L-Bracket
The L
-bracket mounts to the back of a C-series tile via 2x M10 threaded inserts.
Use M10
-
16 (16mm long) bolts only.
The torque specification for this M10-
16 bolt is 16.9 N
-
m.
14 . 2. C
-
series Tile
PXL System