Filter
Top Products
System manual MeDis 5MP1HM 83
MEDICAL SOFTWARE INSTALLATION
Install MediCal on the PC. Follow the instructions from the MediCal
User Guide.
Important: Do not forget you have to have Administrator privileges to
install or uninstall MediCal.
OPTICAL SENSOR CONNECTION
If you are using an X-Rite DTP92 sensor for conformity calibration and
consistency check, connect the sensor to one of the display's Sensor
plugs or to a free PC COM port.
USING MEDICAL
You can now use MediCal to configure the complete configuration
and set up the Q/A tasks.
Proceed as follows:
1 Start MediCal. If appropriate, you can connect to MediCal
Administrator.
2 Set up the configuration in MediCal by using the Configuration
Setup wizard.
3 If necessary, align the displays' geometry settings.
4 For all the displays in the system, check if the DPMS setting is
turned on. Therefore, right-click on the display icon and select
Properties... from the drop-down menu. Then click on Details...
Check if the Powersave option is checked. If not, check it. This is
necessary to use the DPMS possibilities of the imaging board.
5 For all the displays in the system, define (if necessary) and select
a Preset.
6 After selecting the Preset, MediCal starts consistency calibration
automatically.
7 Define the Q/A task schedule.
8 Run the due tasks.
Please refer to the MediCal User Guide for more information.
MediCal software installation and usage