Filter
Top Products
System manual MeDis 5MP1HM 43
Installing the BarcoMed 5MP2 AURA, 5MP2,
5MP1HM, 5MP1H or 4MP2 Windows XP Software
SPECIAL NOTE: Prior to installing the BarcoMed drivers you MUST
install the BarcoMed Display Controller(s), connect the high resolution
display(s) to the controller(s), and turn the high resolution display(s)
on. Refer to the Hardware Installation section of this manual for
instructions on installing the BarcoMed Display Controller(s) and
connecting them to the high resolution display(s).
The following software installation instructions presume that Windows
XP is already installed on your system. If you need to install or
reinstall Windows XP on your system you must first remove the
BarcoMed Display Controller(s) and use a 3
rd
party VGA controller and
VGA monitor during the Windows XP installation process.
Using the BarcoMed Product Installation Wizard
To install your BarcoMed 5MP2 AURA, 5MP2, 5MP1HM, 5MP1H or
4MP2 Windows XP Display Controller Driver and BARCO DPMS
Screen Saver for the first time follow the steps below. If you are
reinstalling the drivers or installing a new driver release over an
existing driver release skip to the step 7 on the next page:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the Hardware Installation Guide that came with
your BarcoMed Display Controller(s) for more information.
2. Boot the machine and log in using an account with administrative
privileges.
3. Windows XP will do a thorough inspection of your system and will
announce that it has found new hardware. Please be patient as
this may take up to 5 minutes.
4. Close any informational balloons that Windows XP may open in
the lower right hand corner of the monitor.
5. If you are installing the BarcoMed 5MP2 AURA or 5MP1HM
Display Controller, Windows XP will automatically launch the
Found New Hardware Wizard, click Cancel to exit the Wizard.
Continue to click Cancel until Windows XP stops launching the
Found New Hardware Wizard - Video Controller.
If you are installing the BarcoMed 5MP2, 5MP1H or 4MP2 Display
Controller, Windows XP will identify the controller as a Metheus
Megapixel Display Controller, but will not install any driver from its
Plug and Play library of device drivers.
6. Windows XP may also tell you that it has finished installing new
devices and may ask you if you want to restart your computer. If it
does, click No.
BarcoMed driver and software installation