Filter
Top Products
System manual MeDis 5MP1HM 47
If DualView is not enabled, you will see a single virtual screen in
the display properties dialog for both heads of a BarcoMed Display
Controller. If DualView is enabled, you will see a two virtual
screens in the dialog box on the Settings Tab of the Display
Properties Control Panel, one for each head of the BarcoMed
Display Controller.
If you wish to enable DualView simply click Next to continue. If
you do not wish to enable DualView clear the checkbox next to
Enable the DualView device?, and click Next to continue.
13. The Device Confirmation screen displays the device driver that
will be installed. If you want to change your selection, click Back
to return to the Device Selection Screen. Click Next to begin
installing the driver. Click Cancel to abort the driver installation.
Special Note: Once you click Next, you cannot cancel the driver
installation.
14. Prior to beginning the installation the BarcoMed Driver Install
Wizard will warn you that while the driver is being installed your
display may flicker. Click OK to continue.
15. When the screen shown in figure 27below appears, click
Continue Anyway. This screen may appear multiple times.
Figure 21
17. When the Wizard tells you that it has successfully installed the
selected driver, click Finish. The wizard will now begin installing
the next selected piece of BarcoMed Software. If you are working
with the default selections, this will be the BARCO DPMS
InstallShield Wizard. Please turn to the section, BARCO DPMS
Screen Saver Installation.
BarcoMed driver and software installation