Filter
Top Products
System manual MeDis 5MP1HM 52
Repeat steps 2 - 7 for each aditional BarcoMed 5MP1HM display
controlled installed in your system.
If you are using a Quad-Head Configuration repeat all of the above
steps for the two displays on the second display controller.
Special note: After setting the resolutions in a Quad-Head
Configuration you may need to drag the heads into the proper position
in the window on the Settings tab, so that the arrangement in the
window on the Settings tab matches the physical arrangement of
your configuration.
Use the BarcoMed Driver Tab of the Display Properties Control
Panel to verify or change your system settings.
Figure 26: Windows XP Display Properties Settings Tab after the
BarcoMed 5MP2 AURA driver has been installed
and the resolution set.
Note: The system shown in figure 26 is a dual-head, single BarcoMed
5MP2 AURA Display Controller, no 3
rd
party VGA controller
configuration, your system may look different.
BarcoMed driver and software installation