Filter
Top Products
System manual MeDis 5MP1HM 23
Connection of the Remote cables
Note: One of the remote cables is packed inside the MediCal box.
1 The Remote cables that come with MeDis are not numbered. It
does not matter which cable you connect to which display, as long
as you take the Remote inputs and outputs on the displays into
account.
2 Take one of the remote cables from the MeDis system. Plug in its
D9 female connector into one of the PC's serial ports (e.g., COM1).
If the port has 25 pins, use the D25-to-D9 interface you find in the
MediCal software box to connect the remote cable.
Plug the other end, the D9 male connector, into the Remote In
connector on one of the MGD 521 displays.
3 In case of a multi-board system, take a second Remote cable. Plug
the D9 female connector into the Remote Out connector of the
display you have connected in step 2. Plug the other end of the
cable into the Remote In connector of another display.
4 Proceed in this way until all displays are daisy-chained through the
Remote bus.
Power up the system
Connect the displays and PC to the power supply. Switch on all the
devices.
Display installation