Filter
Top Products
System manual MeDis 5MP1HM 29
Installing the BarcoMed 5MP2 AURA, 5MP2,
5MP1HM, 5MP1H or 4MP2 Windows 2000
Software
SPECIAL NOTE: Prior to installing the BarcoMed drivers and related
software you MUST install the BarcoMed Display Controller(s),
connect the high resolution display(s) to the card(s), and turn the high
resolution display(s) on. Refer to the Hardware Installation section of
this manual for instructions on installing the BarcoMed Display
Controller(s) and connecting them to the high resolution display(s).
The following software installation instructions presume that Windows
2000 is already installed on your system. If you need to install or
reinstall Windows 2000 on your system you must first remove the
BarcoMed Display Controller(s) and use a 3
rd
party VGA card and
VGA monitor during the Windows 2000 installation process.
Using the BarcoMed Product Installation Wizard
To install your BarcoMed 5MP2 AURA, 5MP2, 5MP1HM, 5MP1H or
4MP2 Windows 2000 Display Controller Driver and BARCO DPMS
Screen Saver for the first time follow the steps below. If you are
reinstalling the drivers or installing a new driver release over an
existing driver release skip to the step 5:
1. Install the BarcoMed Display Controller(s) into your machine.
Please refer to the Hardware Installation Guide that came with
your BarcoMed Display Controller(s) for more information.
2. Boot the machine, and log in using an account with administrator
privileges.
3. If you are installing the BarcoMed 5MP2 AURA or 5MP1HM
Display Controller, Windows 2000 will automatically launch the
Found New Hardware Wizard, click Cancel. Continue to click
Cancel until Windows 2000 stops launching the Found New
Hardware Wizard - Video Controller.
If you are installing the BarcoMed 5MP2, 5MP1H or 4MP2 Display
Controller, Windows 2000 will identify the controller as a Metheus
Megapixel Display Controller, but will not install any driver from its
Plug and Play library of device drivers.
4. Windows 2000 may advise you that it has finished installing all the
new devices in your system and that you must reboot your system
in order for the changes to take effect. If it does, click No.
5. Insert your BarcoMed Software CD into your computers CD drive.
The BarcoMed Product Installation Wizard should start
automatically. If it doesnt start within 3 minutes, browse the
BarcoMed driver and software installation