Filter
Top Products
System manual MeDis 5MP1HM 77
Figure 36
To create a new scheme by modifying one of the three default
schemes please do the following.
1. Open the Display Properties Control Panel by right clicking on an
empty space of the desktop and selecting Properties from the
drop down menu; then select the Screen Saver tab.
2. Select the BARCO DPMS Screen Saver in the Screen Saver
drop down menu if it is not already selected.
3. Click on the Settings button. The BARCO DPMS Screen Saver
Control Panel will open.
4. Select one of the default schemes from the Current Scheme drop
down menu.
5. Set the Work Schedule by setting the beginning and ending time of
your work day for each day of the week.
6. Select the screen saver you wish to use during the work day in the
Screen Saver During Work Day section.
7. Select the amount of time you wish to spend in the Stand-By and
Suspend states after the work day has ended. Please note that
after the time specified has elapsed when you are in Stand-By or
Suspend, you will automatically go into the Off state.
8. Select the amount of time it takes for your display to warm up. If
you have a Barco Medical Display, select Barco Quick Start. If
you are using a non-Barco display, select the amount of time it
takes your display to warm up via the Monitor Setting section.
Contact your display vendor for this warm-up time. On Barco
CORONIS displays, the I-GUARD will stabilize the image within a
few seconds after the display returns to the active state, thus
eliminating the need for a warm-up period at the beginning of the
work day.
9. If you wish to use this DPMS screen saver as the screen saver at
logon time, check the Use As Logon Screen Saver box in the
Additional Options section.
BarcoMed controller tools