Filter
Top Products
System manual MeDis 5MP1HM 57
BARCOMED DRIVER TAB
Introduction
After the BarcoMed Windows Display Controller Driver is installed, a
new Display Properties tab is available for configuring special features
of the BarcoMed Display Controller. Please note that you must have
logged on to Windows using an account with administrator privileges
in order to use the BarcoMed Tabs of the Windows Display Control
Panel to change any display settings.
1) Open the Display Properties Control Panel by right clicking on the
desktop, then select Properties..
2) Under Windows NT 4.0, Click on the BarcoMed Driver Tab (see
figure 27, below).
Under Windows 2000, click on Settings tab. Double click on the
rectangle that represents the BarcoMed Display Controller to bring
up its property page. Click on the BarcoMed Driver tab
(see figure 28 on the next page).
Under Windows XP, click on Settings tab. Double click on the
rectangle that represents the BarcoMed Display Controller to bring
up its property page. Click on the BarcoMed Driver tab
(see figure 29 on the next page).
Figure 27: BarcoMed Driver Tab under Windows NT 4.0
BarcoMed controller tools