Filter
Top Products
System manual MeDis 5MP1HM 16
should now remove any third party VGA controller from your system or
disable the integrated VGA controller.
If you decide to use a separate VGA card and monitor as your boot
monitor, you must disable the on-board VGA capabilities of the
BarcoMed 5MP1HM by moving the jumper to the bottom two pins at J-
1.
Figure 2: VGA Jumper Enlarged View
NOTE: To use multiple 5MP1HM controllers in a single host with VGA
enabled, you need to enable VGA on only ONE of the 5MP1HM
controllers and disable VGA on ALL other BarcoMed controllers.
Examples of PCI Slots
The BarcoMed 5MP1HM is a 64bit PCI controller. To obtain full
performance, it needs to be installed in a 64bit slot. Figure 3
illustrates the types of slots so that you can correctly identify which
one to use for the 5MP1HM.
Figure 3: PCI and RAID Controller Slots
Display Controller installation