Filter
Top Products
5 - 72
ENG
CRANKCASE
SEPARATING THE CRANKCASE
1. Separate:
• right crankcase 1
• left crankcase 2
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Remove the crankcase bolts.
NOTE:
_
• Loosen each bolt 1/4 of a turn at a time and
after all the bolts are loosened, remove
them.
• Loosen the bolts in stages, using a criss-
cross pattern.
b. Remove the right crankcase.
NOTE:
_
Insert a screwdriver or pry bar into the pry
points in the crankcase and then carefully pry
apart the crankcase halves.
CAUTION:
_
Use a soft hammer to tap on one side of the
crankcase. Tap only on reinforced portions
of the crankcase. Do not tap on the crank-
case mating surfaces. Work slowly and
carefully. Make sure that the crankcase
halves separate evenly.
c. Remove the dowel pins and O-ring.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
1
2
CHECKING THE OIL STRAINER AND OIL
DELIVERY PIPE 3
1. Check:
• oil strainer
Damage → Replace.
Contaminants → Clean with engine oil.