Filter
Top Products
4 - 67
CHAS
HANDLEBAR
4. Install:
• left handlebar switch 1
NOTE:
_
Align the projection a on the left handlebar
switch with the hole b in the handlebar.
a
b
1
5. Install:
• clutch lever
• clutch lever holder 1
NOTE:
_
Align the mating surfaces of the clutch lever
holder with the punch mark a on the handle-
bar.
1
a
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
6. Install:
• throttle grip 1
• throttle cables 2
• right handlebar switch 3
• grip end
NOTE:
_
• Lubricate the inside of the throttle grip with a
thin coat of lithium-soap-based grease and
install it onto the handlebar.
• Route the throttle cables through the slot in
the right handlebar switch, and then install
the cables.
• Align the projection a on the right handlebar
switch with the hole b in the handlebar.
• There should be 1 ~ 3 mm (0.04 ~ 0.12 in) of
clearance c between the throttle grip and
the grip end.
7. Install:
• throttle cable holder
WARNING
_
Make sure the throttle grip operates
smoothly.
2
1
3
a
b
C
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)