Filter
Top Products
4 - 18
CHAS
REAR WHEEL, BRAKE DISC, AND REAR WHEEL
SPROCKET
2. Install:
• rear wheel
• washer (O)
• rear axle
• washer (N)
• rear axle nut
NOTE:
Install the washer with the “N” mark on the
right-hand side of the vehicle and the washer
with the “O” mark on the left-hand side of the
vehicle. Be sure to install both washers with
the marks facing outward.
3. Adjust:
• drive chain slack
Refer to “ADJUSTING THE DRIVE CHAIN
SLACK” in chapter 3.
4. Tighten:
• wheel axle nut
5. Install:
• chain cover
• chain cover bolts
• stabilizer (XT660X)
EAS00575
ADJUSTING THE REAR WHEEL STATIC
BALANCE
NOTE:
_
• After replacing the tire, wheel or both, the
rear wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub
installed.
1. Adjust:
• rear wheel static balance
Refer to “ADJUSTING THE FRONT
WHEEL STATIC BALANCE”.
Drive chain slack
40.0 ~ 55.0 mm (1.57 ~ 2.17 in)
T
R
.
.
105 Nm (10.5 m · kg, 75 ft · lb)
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)