Filter
Top Products
5 - 49
ENG
CLUTCH
NOTE:
_
• To install the clutch cover, position the pull
rod so that the teeth face towards that rear of
the motorcycle.
• Tighten the clutch cover bolts in stages and
in a crisscross pattern.
8. Install:
• pull lever spring
1
• pull lever
2
• washer
• circlip
NOTE:
_
• Install the pull lever with the “UP” mark facing
up.
• Align the punch mark
a
on the pull lever with
the punch mark
b
on the clutch cover.
• Install the pull lever spring
1
as shown.
1
2
a
b
New
9. Install:
• clutch cable
1
10.Check:
• clutch cable length
a
Out of specification
→
Adjust.
NOTE:
• Push the pull lever in direction
b
and check
the cable length
a
.
• Bend the tab
c on the pull lever to secure
the clutch cable.
11.Adjust:
• clutch cable length
NOTE:
Move the pull lever a notch until the cable
length is within specification.
12.Adjust:
• clutch cable free play
Refer to “ADJUSTING THE CLUTCH
CABLE FREE PLAY” in chapter 3.
Clutch cable length
65.6 ~ 73.9 mm (2.58 ~ 2.91 in)
1
a
b
c