Filter
Top Products
5 - 68
ENG
STARTER CLUTCH AND A.C. MAGNETO
5. Tighten:
• A.C. magneto rotor nut 1
NOTE:
_
• While holding the A.C. magneto rotor 2 with
the sheave holder 3, tighten the A.C. mag-
neto rotor nut.
• Do not allow the sheave holder to touch the
projection a on the A.C. magneto rotor.
6. Install:
• gasket
• A.C. magneto cover
NOTE:
Tighten the A.C. magneto cover bolts in
stages, using a crisscross pattern.
7. Install:
• neutral switch lead 1
NOTE:
Route the neutral switch lead so that it is taut
and route it under the speed sensor lead 2 as
shown.
a
5 mm or more
Sheave holder
90890-01701
1
3
2
a
T
R
.
.
80 Nm (8.0 m · kg, 58 ft · lb)
New
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)